Lectrosonics VRFIELD (Narrowband) - Manual (Page 17)

Digital Hybrid Wireless™ Modular Receiver System
4.. Windows will search the CD for the driver and when
it has found it. If a dialog box opens warning you
that the driver has not passed Windows Logo Test­
ing, click “Continue.Anyway”.
5.. When the driver installation is complete, the final
page of the Wizard appears. Click “Finish”.to
close the Found.New.Hardware.Wizard.
USB Driver Installation (Windows XP) -
Subsequent Installations
The Windows XP operating system regards all Lec­
Net2 ™ devices as separate USB devices because each
has a unique serial number. Because of this, Windows
XP will want to install the USB driver every time it
encounters a LecNet2 ™ device whose serial number it
does not recognize. However, the process is simplified if
the LecNet2 ™ USB driver has already been installed at
least once before on the same computer system. Use
the following procedure if the LecNet2 ™ USB driver was
previously installed on the computer system.
1.. On the first page of the Wizard, select Install.the.
software.automatically.Recommended) then click
“Next>”.
2.. Windows will discover the previously installed
driver. If a dialog box opens warning you that the
driver has not passed Windows Logo Testing, click
“Continue.Anyway”.
3.. When the driver installation is complete, the final
page of the Wizard appears. Click “Finish”.to
close the Found.New.Hardware.Wizard.
USB Driver Installation (Windows 2000) -
First Time
Use the following procedure when LecNet2 ™ device is
connected to the Windows 2000-based PC for the first
time.
1.. Connect a USB cable between the VR Field Receiv­
er’s USB port and the USB power on the computer
system. Place the LecNet2 ™ Installation Disk in the
PC’s CD-ROM drive and click “ Next>” to display the
next page.
2.. Select Search.for.a.suitable.driver.for.my.device.
(recommended).and click “Next>” to continue.
Rio Rancho, NM 1