Luminex xPONENT 3.1 - Manual (Page 39)

27
Touring the Software
Analytes Tab
Use this tab to select or edit analytes used in the batch or protocol.
FIGURE 13. Analytes Tab
This tab contains the following:
Analyte grid. A grid representing each analyte from 1 to 100. Select All selects all
analytes, and Deselect All deselects all analytes. Click a numbered analyte to select it;
click the analyte again to deselect it. You can also click and drag to select groups of
analytes. Selected analytes are red. Deselected analytes are gray. An analyte marked as
an intra-well normalization bead is blue.
Default Analysis. The default analysis changes based on the Analysis Type selected in
the Settings tab. You can change the analysis settings for all analytes by clicking Change
if the button is enabled in this tab. This displays the Analysis Settings dialog box.