Luminex xPONENT 3.1 - Manual (Page 75)

63
Touring the Software
• Calibrator - If a calibration reagent is selected, the Lot Details table displays Channel
and Target information.
• Verifier - If a verification reagent is selected, the Lot Details table displays target
information.
Import Kit. Opens the Import Calibration or Performance Kit dialog box to import a kit.
Import. Opens the Import Calibrator or Verification Lot dialog box to import a lot.
Export. Opens the Export Calibrator or Verification Lot dialog box. Select a name and
location to save the calibrator or verification lot and click Save.
Add New. Adds a new lot. Add information in the Lot Details section on the right side of
the window. Type a Lot #, Expiration, and target in the appropriate boxes and fields. Click
Save to save the lot, or select Cancel to cancel the entry.
Delete. Deletes a lot selected in the Active Reagents list.
Cmds & Routines Tab
Use this tab to create a routine or to edit, delete, or run a selected routine or command.
You can also run one or more maintenance commands with or without saving them as a
routine.
FIGURE 39. Maintenance Commands and Routines Tab
This tab contains the following:
Routine Name. This list of pre-set routines and commands can be used for system
maintenance. Some of these commands are also available on the Auto Maint tab.
However, you can also add commands to non-Luminex routines on this tab. Additionally,
you can create custom routines on this tab, which display in the Routine Name list once
you save the routine. Select one of the following routines: