Meriam M202 Precision Absolute Manometer - Manual (Page 10)

M2 Series Instruction Manual 9R68-A
Mar, 2008
www.meriam.com
page 10 of 36
3. Program Mode
The program mode is used to configure the manometer for
Measure Mode operation. After the PRGM key is pressed in
Measure Mode, the top line of the display reads “PROGRAM
MODE”. The bottom line reads “UNITS SELECT”. Press the or
arrow keys to scroll through the Program Mode to the desired
register. The configurable registers found in the Program Mode
are Units Select, Damp Rate Select, User Info Select, Contrast
Select, Sea Level Select, Data Logging, Leak Test and Exit.
Press the PRGM key to select any of these configurable registers.
The manometer can be put into Program Mode at any time during
Measure Mode operation by pressing the PRGM key. If Lockout
is set, the correct code must be entered when prompted (see the
User Info / Lockout section of this manual for more information on
Lockout).