Meriam M202 Precision Absolute Manometer - Manual (Page 18)

M2 Series Instruction Manual 9R68-A
Mar, 2008
www.meriam.com
page 18 of 36
User Info Select
The User Info Select registers are designed to provide the user with
information on the hardware and software in the manometer. This
register provides read only information on the sensor’s serial
number, software version and date of manufacture. It also allows
the user to edit the Auto Shut-Off, Lockout and Start-Up Header
Name features.
To access the User Info Select registers, follow the steps below. To
configure a User Info Select register, follow the steps shown on the
following page.
Keystroke Display
1. From the Measure Mode
press the PRGM key. Top line reads “PROGRAM
MODE” and bottom line reads
“UNITS SELECT”.
2. Press the arrow key
twice
Bottom line changes to “USER
INFO SELECT”.
3. Press the PRGM key. Bottom line shows serial
number.
4. Press the arrow key. Software version number
shown.
5. Press the arrow key. Manufacture date shown.
6. Press the arrow key.
See instructions to set
AUTO SHUT-OFF later in
this manual.
Top line reads “AUTO SHUT
OFF” and bottom line reads
“ENTER TO SELECT”.
7. Press the arrow key.
See instructions for using
LOCKOUT later in this
manual.
Top line reads “LOCKOUT
CODE” and bottom line reads
“ENTER TO SELECT”.
8. Press the arrow key.
See instructions for editing
the Header later in this
manual.
Top line reads “HEADER
NAME” and bottom line reads
“MERIAM”. The cursor flashes
at bottom left.
9. Press the arrow key to
go back to “USER INFO
SELECT” screen. Top line reads “PROGRAM
MODE” and bottom line reads
“USER INFO SELECT”.