Meriam M202 Precision Absolute Manometer - Manual (Page 21)

M2 Series Instruction Manual 9R68-A
Mar, 2008
www.meriam.com
page 21 of 36
Header Name
Follow the steps below to edit the Header Name.
Keystroke Display
1. From the Measure Mode
press the PRGM key. Top line reads “PROGRAM
MODE” and bottom line reads
“UNITS SELECT”.
2. Press the up arrow key
twice. Bottom line changes to “USER
INFO SELECT”.
3. Press the PRGM key. Bottom line shows serial
number.
4. Press the up arrow key
five times. Top line reads “HEADER
NAME” and bottom line reads
“MERIAM”. The cursor flashes
at bottom left.
5. If header is correct press
backspace key. If editing is
desired proceed to step 7. Top line reads “PROGRAM
MODE” and bottom line reads
“USER INFO SELECT”.
6. Press the left arrow key. Returns to Measure Mode.
7. Press the up or down
arrow keys to set the
correct alpha-numeric
value. Displays a number between 0
and 9, a letter from A to Z, / or a
blank space.
8. Press the right arrow key
to accept entry. Cursor advances one space to
right.
9. Repeat steps 8 and 9
until the desired Header is
shown.
10. If an error is made press
the back arrow key until the
cursor is over the incorrect
value. Follow step 8 to
correct. Press the right
arrow key to advance the
cursor without changing
values.
11. When the Header is
complete press the PRGM
key until header accepted. Top line reads “PROGRAM
MODE” and bottom line reads
“UNITS SELECT”.
12. Press the left arrow key. Returns to Measure Mode.