Micromod Micro-DCI: 53SL5100A Single Loop Controller - Manual (Page 33)

Single Loop Process Controller Instruction Manual
Front Panel 25
Table 3-1. Pushbutton Functions
Push-
button
Title Operator Mode Engineering Mode
R/L Remote/Local
Select This pushbutton is used to select
between Remote setpoint control
and Local setpoint control.
When in Remote, an R appears
in the lower right of the display.
When in Local, an L appears in
the lower right of the display.
↑ Setpoint Increase
(EMODE Character
Select) The setpoint indicator increases
(rises) when this pushbutton is
pressed and held. Release the
pushbutton when the desired
setpoint level is reached. This
pushbutton is for Local operation
only. For configure or display
functions, the character set
displays one character at a
time in ascending
alphanumeric order when this
pushbutton is pressed and
held. Release the push button
when the desired character,
number, or symbol appears.
For configure or display
functions, the character set
displays one character at a
time in descending
alphanumeric order when this
push button is held pressed.
Release the pushbutton when
the desired character, number,
or symbol appears.
↓ Setpoint Decrease
(EMODE Character
Select) The setpoint indicator decreases
(falls) when this push button is
pressed and held. Release the
pushbutton when the desired
setpoint level is reached. This
pushbutton is for Local operation
only. For configure or display
functions, the character set
displays one character at a
time in descending
alphanumeric order when this
pushbutton is pressed and
held. Release the pushbutton
when the desired character,
number, or symbol appears.