Minuteman Kleen Sweep 40R-47R HM50QP - Manual (Page 34)

Maintenance/Service
7.4 Sealing Strips for Broom
Compartment
In order to assure good function of the
sweeper, a perfect condition of the
sealing strips is required, especially in
order to attain the prescribed vacuum in
the broom compartment, a clean
sweeping result and the less possible
wear of the sealing strips (check the
sealing strips of the broom compart-
ment for wearing and damages in regu-
lar intervals).
Replace defective sealing strips.
The ground clearance of the lateral and
of the rear sealing strips is adjustable
(oblong holes in the sealing strips).
Ground clearance =
sides: approx. 0.04 in. (1mm)
rear: approx. 0.16 in. (4mm).
Proceed to adjustment at the Kleen
Sweep 40R/47R with the battery set
being mounted
Height of the front sealing strip (at fol-
ding apron) cannot be adjusted. Being
dragged, it has contact with the floor.
7.4.1 Folding Apron Adjustment
Fig. 14 Adjust folding apron
- Turn engine off and remove key
- disconnect battery plug
- Remove cover (as described in the
paragraph “Mount/Dismount Cylinder
Broom”).
- Remove bolt (Fig. 14/2).
- Modify adjustment by turning the fork
head (Fig. 14/1).
Modify adjustment such that the cylin-
der broom does not retract the sealing
strip of the folding apron during operati-
on.
34