MotorVac CarbonClean System II LE-1 - Manual (Page 12)

Overview
1998 MotorVac Technologies, xi
Before You Begin
First Time Operation
NOTE
The following process is used to flush factory
testing fluids out of your new machine, and is
only necessary before the first time you use the
unit.
1.
Verify that the LE-1’s fuel filter is connected and securely in place in the rear of the cabinet.
2.
Check the output/return hoses, battery connections, and all external components for damage.
3. Turn
the Pressure Adjust regulator on the unit control panel counterclockwise until it is
completely open.
4.
Attach the unit to the vehicle's battery by connecting the red battery clip to the positive (+)
battery terminal and the black battery clip to a solid ground point as far from the battery as
possible. Turn on the LE-1 power switch.
5.
Fill the LE-1’s reservoir with clean gasoline until the tank level indicates 1/4 tank.
6. Connect the LE-1’s output (red) hose and return (black) hose together by using the
#060-1400 adaptors and securing them with a clamp. Follow the procedures below to flush fuel
through the system:
• Set the Timer knob for five minutes.
• Press and hold the Start/Run switch for five minutes.
• Release the Start/Run switch.
7. Disconnect the output and return lines.
8.
Connect the #060-1400 adaptor to the output hose, then drain the gasoline from the LE-1’s
reservoir using the following procedure:
• Set the Timer knob for five minutes.
• Direct the output (red) hose into an appropriate container.
• Press and hold the Start/Run switch until the fuel from the unit has been emptied into the
container.