Multichannel Systems STG4004+STG4008 Manual - Manual (Page 14)

Stimulus Generator 4000 Series Manual
10
3.4 Installing the Software
System requirements
Software: One of the following Microsoft Windows ® operating systems is required:
Windows 7, Vista or Windows XP (English and German versions supported).
Hardware: USB port (2.0 High Speed)
Installing the software
Please check the system requirements before you install the software. MCS cannot guarantee
that the software works properly if these requirements are not fulfilled.
Important: Please make sure that you have full control over your computer as an administrator .
Otherwise, is possible that the installed software does not work properly.
1. Double-click Setup.exe on the installation volume.
The installation assistant will show up and guide you through the installation procedure.
2. Follow the instructions of the installation assistant. Please select the appropriate maximum
number of analog output channels according to the connected STG. If you have different
STGs in use, choose the highest number.
For the devices with internal stimulation, STG3008-FA and MEA32-STIM4 separate manuals
are available.
When you have finished the installation of the MC_Stimulus II software and the STG driver,
you can now operate the STG.