ADT Security Services Safewatch Pro 2000 - Manual (Page 17)

– 17 –
DISARMING AND SILENCING ALARMS
Using the
1 OFF Key
IMPORTANT:
If you return and the
main burglary sounder
is on, DO NOT ENTER, but
CONTACT THE POLICE from
a nearby safe location.
If you return after an alarm
has occurred and the main
sounder has shut itself off,
the touchpad will beep
r a p i d l y u p o n y o u r
entering, indicating that
an alarm has occurred
during your absence.
LEAVE IMMEDIATELY, and
CONTACT THE POLICE from a
nearby safe location.
The OFF key is used to disarm the system, silence alarm and trouble sounds, and clear
alarm memories.
A BURGLARY alarm is a continuous/steady sound from the
touchpads and any external sounders.
To Disarm the System
Enter your security code and press the OFF key.
The "Ready" indicator light will be lit if all zones are secure, and the touchpad will emit a
single tone to confirm that the system is disarmed.
To Silence a Burglary Alarm
SEE IMPORTANT NOTE AT LEFT!
A BURGLARY alarm is a continuous/steady sound.
Enter your security code and press the OFF key to silence the alarm (or warning tones
of a Memory of Alarm).
Note the zone in alarm on the touchpad display, and make that zone intact (close door,
window, etc.). Now enter the security code plus OFF sequence
again to clear the
touchpad's Memory of Alarm display.
To Silence a Fire Alarm
Simply press the OFF key to silence the alarm. Then enter the security code plus
OFF sequence to clear the touchpad's Memory of Alarm display. See
FIRE ALARM
SYSTEM section.
TYPICAL BURGLARY ALARM DISPLAY
ALA RM 0 6
BE DR OO M WIN DO W
06
ALARM
AC
CUSTOM DISPLAY TOUCHPAD ENGLISH DISPLAY TOUCHPAD