ADT Security Services Safewatch Pro 2000 - Manual (Page 30)

– 30 –
TROUBLE CONDITIONS (Continued
)
Words or letters in parentheses ( ) are those that are displayed on English Display
Touchpads.
[
Other Trouble
Displays
* Any “beeping” that
accompanies a
trouble display can be
stopped by depress-
ing any key on the
touchpad or by
entering an OFF
sequence (code +
OFF)
** Not all systems use
wireless sensors.
1. COMM. FAILURE Indicates that a failure has occurred in the telephone com-
(or FC) munication portion of your system.
CALL FOR SERVICE IMMEDIATELY.
2. SYSTEM LO BAT Indicates that a low system battery condition exists. Display
(or BAT with no zone No.) is accompanied by "beeping"* at the Touchpad. If this
condition persists for more than one day (with AC present),
CALL FOR SERVICE.
3. LO BAT + zone descriptor Indicates that there is a low battery condition in the wireless
(or BAT with zone No.) transmitter** number displayed. Accompanied by a single
"beep"* (once every 40 seconds) at the Touchpad.
Either replace the battery yourself, or CALL FOR SERVICE.
If the battery is not replaced within 30 days, a C H E C K
display may occur.
4. Rcvr Jam Wireless part of the system is experiencing RF interference
(or CHECK 90) which may impede reception from wireless sensors.**
5. MODEM COMM
(or CC)
Indicates that the control is on-line with the Customer Care
Center's remote computer. The control will not operate
while on-line. Wait a few minutes. Display should disappear.
6. BELL FAILURE Indicates that the wiring connection to the external sounder
(or CHECK 70) is at fault (open or shorted). Accompanied by “beeping” at
the touchpad. CALL FOR SERVICE IMMEDIATELY.