Chapter 3. programming – Pach and Company AeGIS 4000_4000RT Manual User Manual

Page 17

Advertising
background image

CHAPTER 3. PROGRAMMING

CHAPTER 3. PROGRAMMING

The AeGIS 4000 can be programmed Local (using built-in keypad), Premise Phone or Remote Phone. Premise phone
programming can only be used if the existing Central Office Line is connected to the system as shown in figure 2.1.

Pach and Company

Page 8

AeGIS 4000

Chapter 3. Programming

Local Programming

Premise Phone

Remote Phone

Keys

Press this key once to exit from the
programming mode, you may need to
press the key twice to exit if you
already in the select function mode

Press this key
• once to accept program.

These keys is used to Reset the
Master Code to factory default.

Step 1

Open the panel and turn the

power switch to OFF, see
figure 2.1 to locate the power switch.

Step 2

Press and hold

∗ and # key

simultaneously and turn the system’s
power “On” (switch to the left). You will
hear “Two Short

Beeps” then

“Three Short Beeps” then release the
∗ and #. Your master code is now
0000.

Press this key
• Twice to initiate the call to the

AeGIS 4000, see function code

98 (must be selected to use * ).

• Twice to disconnect the call with

the AeGIS 4000.

Press this key
• Twice to initiate the call to the

AeGIS 4000, see function code

98 (must be selected to use #).

• Once to Extend the talk time for

another cycle.

• Once to accept program.

Press this key twice to disconnect the
call with the AeGIS 4000.

Press this key once to accept
program.

*

#

* and #

RESET MASTER

CODE

Master Code cannot be replaced using
the premise phone.

Master Code cannot be replaced using
the remote phone.

00

CHANGE UNIT

MASTER CODE

The default system Master Code
(0000) must be changed for security
purposes. The Master Code is always
4-digit long.

Step 1

Entering The Programming

Mode: Press 0 and # simultaneously
then release.
If you are in the
programming mode, proceed to step 2.

Step 2

Enter the 4-digit Master

Code (factory default is 0000) and you
will hear One Short Beep. If you
entered an invalid master code you will
hear “One

Long

Beep”, repeat

step 1. Should your master code
become lost or forgotten see Reset
Master Code.

Function

Local Programming

Premise Phone

Remote Phone

Advertising