Pach and Company AeGIS 4000_4000RT Manual - Manual (Page 33)

ALARM NOTIFICATION
AUXILIARY INPUT PIN (AUI)
DO NOT DISTURB
HOW TO USE SPEED DIALING
Step 2 Dial the AeGIS phone number and you will hear “One Short Beep” if the gate is
locked or “Two Short Beeps“ if the gate is unlocked.
Step 3 Press # then 4-digit master code and you will hear “One Short Beep” if your
master code is accepted or you will hear “One Long Beep” if your master code is
rejected and the system will disconnect.
Step 4 Press ∗, you are ready to talk to the AeGIS system. You may press “9” to open door
or gate.
An alarm notification will occur if someone has been using incorrect access codes in order to
gain access and the number of account has been exceeded the lockout-count limit. The
system will provide an alarm notification local at the AeGIS system or remote (calling into a
premise or remote location phone). Refer Function Code 95.
Mode 0: the AeGIS 4000 will beep every second for 30 seconds and the system cannot be
used for 60 seconds.
Mode 1: the AeGIS 4000 will call to a premise or remote location. If it calls to:
• A premise: distinctive ringing will be heard for 30 seconds if the call is not
answered. If the call is answered, a connection will be established with the AeGIS
system, you may talk to the visitor and press “9” to open door or gate.
• A remote: regular ring will be heard for 30 seconds if the call is not answered. If
the call is answered, you will hear beep … beep … for 60 seconds. You may
press “9” to open door or gate or press any other key to hang-up the call.
The AUI can be set into three different modes and “Two Short Beeps” will be heard if the
AUI input is activated.
Mode 0 is disabled.
Mode 1 is to unlock door or gate if AUI pin is shorted to ground (GND). Door or
gate will remain unlock according to door open interval programmed on
function code 92. You may connect a Postal Lock or a momentary switch
to the AUI input.
Mode 2 is to unlock hold door or gate. You may connect a timer to the AUI input
to unlock and lock door or gate according to the timer setting.
The “Do not Disturb” feature is used to block any visitor call. The AeGIS system will not allow
a visitor to press # to call out. Any other operation will still work. Refer to function code 97 to
Enable Do not Disturb mode.
You may use a speed dialing for frequently used function codes such as Unlock Door Cycle,
Unlock Door Hold and Lock Door, etc. You must put PAUSE between the key presses.
DESCRIPTION ACTION
Pach and Company Page 24
AeGIS 4000 Chapter 4. Operations