Connecting multiple interfaces to your computer, Monitoring live data, Moving on from the home screen – PASCO SPARKvue ver.2.0 User Manual
Page 20: Monitoring live data": 8
1. Click the Device Tools button to open the Device Tools screen.
2. Click the Connect Sensor via Bluetooth button.
3. Click Disconnect.
The selected device will change from Disconnect to Connect upon successful
connection.
4. Click OK twice to close the Device Tools screen.
Connecting multiple interfaces to your computer
n
If the computer has enough available USB ports, connect each interface to a USB
on the computer.
n
If the computer has only one available USB port, connect a powered USB hub to the
computer, and connect the interfaces to the hub.
n
If at least one of the interfaces is a PowerLink, you can connect the PowerLink to the
computer and connect two additional interfaces to the USB ports on the back of the
PowerLink.
Monitoring live data
Live data from all connected sensors are displayed whenever the Home screen is open.
The Home screen is the first screen that appears when SPARKvue starts.
If the Home screen is not visible, click the Home button to return to the Home screen.
Moving on from the Home screen
With the Home screen displayed, you are ready to move into a SPARKlab. A SPARKlab
is a multiple page environment where your science investigation takes place.
Complete one of the following tasks to open an embedded SPARKlab, show a meas-
urement in a SPARKlab, or build a custom SPARKlab.
n
n
n
Document Number: 012-11074D
8
SPARKvue
®
2 Starting an experiment
Monitoring live data