PASCO SPARKvue ver.2.0 - Manual (Page 50)

Entering data into bar graph manually
1. Click the Bar Graph Tools button to open the tool palette.
2. Click the bar you want to edit.
3. Enter a value for the bar.
4. Click OK.
Collecting data for bar graph using a sensor
It is recommended that the bars are given names either before or during data collection.
See
Editing bars and bar names in bar graphs and "Adding bars and bar names in bar
graphs": 36 .
1. Click the record arrow to record data for the first empty bar in a data run.
The first bar becomes active and displays the data being collected, and the record
button changes to a check mark.
2. Click the check mark to stop collecting for the current bar and move to the next bar.
Note : The will remains gray if it does not have a name assigned to it.
3. Click the Stop button to stop collecting data.
Adding additional data runs to a bar graph
You can show multiple data sets in a bar graph at once.
1. If necessary, click the Bar Graph Tools button near the lower left corner of the bar
graph to open the tool palette.
Document Number: 012-11074D 38
SPARKvue
®
5 Data display
Displaying data in a bar graph