PASCO SPARKvue ver.2.0 - Manual (Page 21)

Opening a SPARKlab
SPARKvue includes embedded SPARKlabs. Additional no-cost labs are available from
PASCO. Complete these steps to open a SPARKlab:
1. Connect the sensors required for the SPARKlab that you wish to do.
2. If there are unneeded sensors connected, disconnect them.
3. In the SPARKlabs pane, navigate to the folder containing the SPARKlab that you
would like to open.
4. Click a SPARKlab to preview.
The lab preview opens in the right pane.
5. Click the preview to open the lab.
The SPARKlab opens.
Follow the on-screen instructions to continue your science investigation.
6. Click the Page Navigator to turn pages.
Showing a SPARKlab
A show-path SPARKlab is the fastest way to record data and display it in a graph, table,
digits display, and meter.
Complete these steps to show a SPARKlab:
1. Connect a sensor.
2. In the Home screen, click the measurement that you would like to show.
The selected measurement is highlighted.
3. Click Show.
Note : A measurement must be selected for Show to be available.
A four-page SPARKlab opens.
4. Click the Start button to record data.
Click the Page Navigator to see your data in the different displays.
Document Number: 012-11074D 9
SPARKvue
®
2 Starting an experiment
Moving on from the Home screen