Agilent Technologies 8510XF - Manual (Page 15)

15
Examples of upgrade paths
Figure 10. Upgrading an 85107B 50 GHz system to an 85106D waveguide system to
operate in V-band (or W-band)
Measurement accessories
There are measurement accessories for seven device connector types: 7 mm,
3.5 mm, 2.92 mm, 2.4 mm, 1.85 mm, 1 mm and Type-N. Calibration kits include
standards that are required for vector error correction. Verification kits
include standards used to verify system performance specifications. Test port
return cables extend the ports of the test set and connect to the device under
test. Agilent 85130X adapter sets convert test set ports to the same connector
type (acting as a test port saver) or to a different connector type.
85107B
(45 MHz to 50 GHz)
current system
Upgrade to 85106D waveguide
system to operate in V-band
New equipment needed:
❑ 85105A 1 with
Option 050 2 millimeter-
wave test set controller
❑ 83621B synthesizer
(LO source)
❑ V85104A 3 test set
modules (quantity of 2)
❑ V11644A 3
calibration kit
❑ V11645A 3
verification kit
85105A #050
8510C
8510C
8517B
8517B
83621B
83651B
83651B
1. Standard 85105A already includes IF switching (Option 001)
2. Option 050 provides a 50 GHz RF source switch. This is necessary in order to operate with the
existing 83651B 50 GHz source and 8517B 50 GHz test set.
3. To operate in W-band, replace all V-band components with W-band.