PERKO 0622 - Manual

Cat. No. 0619 Series Bi-Color Lights
Cat No. 0622 Series Side Lights
The above lights are designed for use on power driven vessels under 20 meters (65.6 ft.) in length operating on a
nominal 12 volt system. In order to comply with ‘72 COLREGS and the U.S. Inland Rules, the following must be
adhered to:
MOUNTING INFORMATION
Read all instructions before proceeding
1). For proper light selection, positioning and configuration, refer to the A.B.Y.C. Standard A-16*, the ‘72 COLREGS* and the
U.S. Inland Rules*.
2). These lights are designed to be mounted on a horizontal surface.
3). Draw a 6 inch long reference line through the center of the selected mounting location and parallel to the centerline of the boat.
4). Cut out the mounting template. Place it on the mounting surface such that the reference line (drawn above) is directly underneath
the reference line marked on the template.
5). Drill 2 holes through the template to accommodate #8 round or pan head mounting screws. Drill a 1/4 inch hole to accommodate
the electric wiring.
6). Attach supply connections to the light, making sure to wire in accordance with both A.B.Y.C. Standard E-9* and U.S. Coast Guard
Safety Standards for Boat Electrical Systems (33 CFR 183)*. These lights are polarity sensitive. Connect red lead to positive and
black lead to negative.
7). Mount the light in accordance with the template. Note that there are thin reference marks around the outside of the base that must
be aligned with the reference line (drawn in Step #3) for final accuracy of mounting orientation.
* The above referenced Standards can be obtained from:
1) American Boat & Yacht Council, Inc 2) U.S. Coast Guard PERKO, Inc.
613 Third Street, Suite 10 Washington D.C. 20593 16490 N.W. 13th Avenue
Annapolis, MD 21403 (or your local C.G. office) Miami, Florida 33169-5707
www.perko.com
TEMPLATE
USCG APPROVAL
33 CFR 183.810
Visibility: 2nm
Tested By: IMANNA Labs.
Dates: 04/22/08
Meets ABYC A-16
05/08
0619INS1