Alto-Shaam Cook - Manual (Page 17)

767-SK/III, 1767-SK/III, 2800-SK/III INSTALLATION / OPERATION / SERVICE MANUAL PG . 15
O P E R A T I N G I N S T R U C T I O N S
Programming a Preset
Select the product to be programmed and begin programming with the oven control power O
FF
.
Press and release control O
N
/ O
FF
key. The oven will beep for one second and power to the unit
will be indicated by an illuminated green indicator light located in the upper left corner of the
O
N
/O
FF
key. The oven will begin operating in the hold mode. The amber H
OLD
indicator will be
illuminated and the last set hold temperature will be displayed.
To set Cook temperature — Press C
OOK
Key. Oven preheat indicator will illuminate and the last
set cooking temperature is displayed. To change the cook temperature, press the U
P
or D
OWN
A
RROW
Keys.
If cooking by time — press the T
IME
Key. The green T
IME
indicator will illuminate and the last set
cooking time will be displayed. To change the set time, press the U
P
or D
OWN
A
RROW
Key. The
display will alternate between the set temperature and the elapsed time.
If cooking by probe — press the P
ROBE
Key. The green P
ROBE
indicator will illuminate and the last
set internal product temperature will be displayed. To change the set temperature, press the U
P
or D
OWN
A
RROW
Key. The display will alternate between the set temperature, the elapsed time,
and the probe temperature.
To set Hold temperature — Press the H
OLD
Key. The green cook indicator light will remain
illuminated. To change the hold temperature, press the U
P
or D
OWN
A
RROW
Key. The display will
alternate between the set hold temperature and the amount of time the product has been in the
hold mode. Oven will remain in the H
OLD
mode until the O
N
/O
FF
key is pressed.
To set Smoke time — Press S
MOKER
Key. To set the smoke time desired, use U
P
or D
OWN
A
RROW
key. The last set time will be displayed.
Select a letter code for the product programmed by the previous steps. Press and hold the selected
P
RESET
key for two seconds. When the preset has been saved, you will hear a one second beep and the
preset light will illuminate.
Note: Only one preset can be programmed at a time. If programming an additional preset is
desired, the unit must be started and stopped either by cycling the power to the cavity or by
pressing the S
TART
/S
TOP
key. The last P
RESET
Key used will be the oven cooking run sequence
for the next product to be programmed. Settings can be manually changed for the next
product and an alternate pre-programmed letter key selected.
Erasing a Preset
To erase a program, the oven must be in either the power-up hold mode or in the preheat mode. The oven
cannot be running a P
RESET
Menu program.
When the oven is in the power-up hold mode or in the preheat mode, press and hold the C
ANCEL
Key and
then the appropriate letter P
RESET
Key to be erased for two seconds. When the preset has been erased the
oven will beep for one second.
IMPORTANT
-
After programming a specific product into memory in a programmable preset
key, it is very important to make a written permanent record of the product and the program letter
assigned. Menu card (PE-23384) is provided for this purpose.