PROLiNK WNR1004 Wireless-N User manual - Manual (Page 13)

PROLiNK® WNR1004 User Manual www.prolink2u.com
Revision 1.0 (Apr’09)
10
3.3.2 Step 2 – LAN
This step can set up Wireless Portable Router’s IP address, subnet mask, DHCP type, DHCP IP
addresses range, DHCP subnet mask and DHCP lease time.
IP Address Shows the IP address of the Wireless Portable Router (Default IP address is
192.168.10.254.)
Subnet Mask The subnet mask of the Wireless Portable Router (Default subnet mask is
255.255.255.0.)
DHCP Type Disable: Select to disable this Wireless Portable Router to distribute IP addresses to
connected clients.
Server: Select to enable this Wireless Portable Router to distribute IP Addresses (DHCP
Server) to connected clients. And the following field will be activated for you to enter
the starting IP Address.
DHCP Start IP The starting addresses of this local IP network address pool. The pool is a piece of
continuous IP address segment. Keep the default value 192.168.10.100 should work for
most cases.
DHCP End IP The end IP address, the maximum is 253. Default value 253 should work for most cases
(192.168.10.253.) If “Start IP Address” is set at 192.168.10.100 and the “End IP address”
is 192.168.10.253, the device will distribute IP addresses from 192.168.10.100 to
192.168.10.253 to all the computers in the network that request IP addresses from
DHCP server (Router).
DHCP Subnet
Mask
The subnet mask of the distribute IP addresses clients, the subnet mask must be set at
the same segment as the Wireless Portable Router.