PROLiNK WNR1004 Wireless-N User manual - Manual (Page 36)

PROLiNK® WNR1004 User Manual www.prolink2u.com
Revision 1.0 (Apr’09)
33
3.5.1.5 Wi-Fi Protected Setup
WPS Config
WPS Select Enable then click Apply to use WPS (Wi-Fi Protected Setup) function, then
push physical WPS button on Wireless Portable Router to make a WPS
connection. Default setting is Disable.
WPS Summary
WPS Current Status After enabling the WPS function, if there is connection the status will show
Configured, otherwise, the status will show Idle.
WPS Configured Trigger WPS AP to do simple config with WPS Client. If WPS configured, here
shows Yes, otherwise, NO.
WPS SSID Shows the Wireless Portable Router network name.
WPS Auth Mode The WPS authentication type supports Open, Shared, WEP Auto, WPA-PSK,
WPA2, WPA2-PSK, WPA-PSK/ WPA2-PSK. Please go to the configuration page
Wireless Settings > Security to set up the WPS security.
WPS Encryp Type For Open authentication mode, the selection of encryption type are NONE and
WEP. For WPA-PSK, WPA2-PSK and WPA-PSK/ WPA2-PSK authentication mode,
the encryption type supports TKIP, AES and TKIP/AES.
WPS Default Key Index Shows the WEP default key (1~4).
WPS Key(ASCII)
Shows the WPS security keys (ASCII). The key can be used to ensure the security
of the wireless network.
AP PIN Here shows the AP’s PIN code (Personal Identification Number) that the enrollee
should enter the registrar’s PIN code to make a connection.
Reset OOB Reset WPS AP to the OOB (out-of-box) configuration.