PROLiNK WNR1004 Wireless-N User manual - Manual (Page 33)

PROLiNK® WNR1004 User Manual www.prolink2u.com
Revision 1.0 (Apr’09)
30
a) Lazy Mode
If Lazy mode be selected, it is unnecessary to set up wireless MAC here, just go to set up Wireless MAC
address on the other wireless AP then WDS function will be active.
Phy Mode Select CCK(11b mode), OFDM(11g mode), HTMIX(11b/g/n mixed mode) or
GREENFIELD(11n mode) from the pull-down menu. Each AP should be setup to
the same Phy mode.
AP1~AP4 Encrypt Type Users should go to the main web page of the Wireless Portable Router Wireless
settings > Security page to set up security mode under Open, Shared, WEP Auto,
WPA, WPA-PSK, WPA2, WPA2-PSK, WPA-PSK/ WPA2-PSK, WPA/WPA2.
Select NONE, WEP, TKIP and AES encryption type from pull-down menu. (Default
encryption type is NONE.)
Encrypt Key Enter the corresponding encryption keys in the field.
Select the type of Open, Shared, WEP Auto authentication, for WEP encryption.
• Hexadecimal (WEP 64 bits) : 10 Hex characters (0~9, a~f).
• Hexadecimal (WEP 128 bits) : 26 Hex characters (0~9, a~f).
• ASCII (WEP 64 bits) : 5 ASCII characters (case-sensitive).
• ASCII (WEP 128 bits) : 13 ASCII characters (case-sensitive).
Select the type WPA, WPA-PSK, WPA2, WPA2-PSK, WPA-PSK/ WPA2-PSK,
WPA/WPA2 authentication, for TKIP or AES encryption.
If users select TKIP or AES encryption, please enter the password in the
Encryption Key column that must be filled with characters longer than 8 and less
than 64 lengths to set up the security.