Reese 50024 TITAN ROUND TUBE SLIDER - Manual (Page 4)

50024N Ŕ 7/5/11 F PCN12170 ©2011 CEQUENT PERFORMANCE PRODUCTS, INC. Printed in XXX
4
3. Before setting the REESE ™ FIFTH Wheel Slider
into the bed of the pickup. Insert the bent
handle(3) through drivers side assembly(2)
(
driver’s side of towing vehicle) and then
through passengers side slide assembly(1). Slide
straight handle(9) over bent handle(3). Install roll
pin(10). See Figure 8. It may be easier to lay the
handles on a firm surface to install the roll pin.
Then insert the handle into the drivers and
passengers assemblies. When installing handle
grip(8), rotate it so the molded finger areas align
for your use. Either left hand or right hand usage.
4. Set the REESE ™ FIFTH Wheel Slider into
base rails and pin in position as shown in
Figure 9 below.
Figure 9
Figure 8
2. Before installing REESE
™
FIFTH Wheel Slider,
the leaf spring must be greased as shown using
white lithium grease or equivalent (see Figure 7). For
best results, use aerosol white lithium grease with a
spray nozzle extension. Make sure entire
underside of spring is coated! Repeat this application
monthly during use.
Safety label facing
driver side.
1. These instructions should be used to mount the REESE
™
FIFTH Wheel Slider. Care and attention to detail will
ensure a quick, safe and quality installation. Check parts against Figure 1 to become familiar with kit.
INSTALLATION
WARNING:
Pull pin spring clips must
be on the outside of base rail
as shown. (Spring clips
installed on the inside of
base rail will not allow Slider
to move far enough to lock).
Sliders that are not properly
locked can suddenly move
and cause serious injury or
death.
Slide Tube
Slide Upright
Aerosol white lithium
grease spray with nozzle
extension
Leaf spring
Figure 7
BASE RAIL
Slip Ring
Slip
Ring