AMX Wall Docking Station MVP-WDS - Manual (Page 12)

MVP-WDS Wall Docking Station & CB-MVPWDS Rough-In Box
6 MVP-WDS Wall Docking Station for MVP Panels
4. Close the battery cover and disconnect the power connector to remove power from the unit and
maintain the support cradle in the forward position.
5. Remove the two #6-32 Faceplate Security Screws from the top rim of the faceplate, using a
grounded Phillips-head screwdriver (FIG. 6).
6. Angle the top rim of the faceplate upwards, and pull it up and over the Security Latch.
7. Grab the bottom rim of the faceplate and push it up (towards the support cradle), then pull it out,
sliding the four faceplate connectors out of the latches along the bottom of the WDS (FIG. 7).
FIG. 5 Cradle activation pushbutton location and cradle angling
FIG. 6 Faceplate screw removal
Battery Compartment Cover
Battery Compartment Latch
Cradle
MVP Support
Activation
pushbutton
Power supply feed
(located inside
Battery Slot #2)
Cradle
Battery slot 2
Battery slot 1
Faceplate
MVP Support Cradle
#6-32 Faceplate
Security Latch
Security Screws
Security Release pushbutton