AMX Wall Docking Station MVP-WDS - Manual (Page 23)

MVP-WDS Wall Docking Station & CB-MVPWDS Rough-In Box
17 MVP-WDS Wall Docking Station for MVP Panels
Removing an MVP Panel from an MVP-WDS
The MVP security feature enables a security code that is entered into an on-screen password keypad.
This password is configured within the MVP panel’s Password Setup page.
Refer to the MVP-7500/8400 Operation/Reference Guide (available online at www.amx.com) for more
information on setting up a User Access username and password.
Unsecured MVP removal from an MVP-WDS
1. Press and hold the security release pushbutton.
The MVP-WDS will release the security latch from the rear of the MVP and the MVP Support
Cradle will angle forward to present the MVP for removal.
2. Lift the panel off the alignment guide pins and remove it from the support cradle.
3. Allow the MVP-WDS one second to retract the Support Cradle.
Secured MVP removal from an MVP-WDS
1. Press and hold the security release pushbutton until the on-screen keypad appears on the MVP.
2. Enter the security release password.
3. Press Done when finished. Allow the MVP-WDS one second to process the release request and turn
off the electromagnet.
4. Angle the MVP forward.
5. Lift the panel off the alignment guide pins and remove it from the support cradle.
FIG. 18 System message - panel is properly docked
On-screen Docking message
Docking Status button
(illuminates to also give an
indication that the panel is
properly docked)
If the MVP is docked properly and communicating, the right LED on the MVP-WDS
will remain brightly illuminated.
Refer to the LED Pattern Indicators for the MVP-WDS table on page 3 for more
information.
If the panel is not securely attached, the electromagnet on the TDS will not be
activated, and the panel could fall forward and be damaged.