AMX Wall Docking Station MVP-WDS - Manual (Page 28)

MVP-WDS Wall Docking Station & CB-MVPWDS Rough-In Box
22 MVP-WDS Wall Docking Station for MVP Panels
4. Carefully remove the cradle pivot’s attachment screw and place it aside for later re-attachment.
5. Carefully slide the black pivot cradle combo unit (battery cover/support cradle) up from the metallic
housing and use the screwdriver to remove the remaining screw from the securing plate (shown in
FIG. 24).
6. Place this securing plate aside (along with its three securing screws).
7. Locate the exposed MVP Interface Connector pin circuit board and use the screwdriver to remove
this board from the combo unit by unscrewing the two screws (A in FIG. 25).
FIG. 23 Separating the support cradle from its movement mechanism
FIG. 24 Sliding out the battery cover/support cradle combo
Support Cradle Pivot
movement mechanism
Long Magnetic
Phillips-head
screwdrivers
Attachment
screw
Gap opening
MVP Support Cradle
Securing plate
Remaining MVP Support
Cradle Securing screw
Use care when removing this black pivot combo as it is still connected to two
separate internal circuit boards along its backside. The removal of these circuit
boards is the last step before installation of the replacement MVP-WDS/Silver unit.