AMX Wall Docking Station MVP-WDS - Manual (Page 27)

MVP-WDS Wall Docking Station & CB-MVPWDS Rough-In Box
21 MVP-WDS Wall Docking Station for MVP Panels
14. Press downward on the Security Latch (towards the pushbutton) to get it to go through the top
opening and allow the faceplate’s removal.
15. Grab the top rim of the faceplate and carefully slide it over the cradle (at an angle) until the faceplate
is completely removed from the MVP-WDS.
Removing the existing black pivot unit (battery and cradle combo)
1. Unscrew the two MVP Support Cradle Securing screws, located on the lower right side of the unit
(just above the USB connectors) (FIG. 22) and set them aside.
2. Insert the screwdriver into the large hole on the side of the existing black WDS housing (FIG. 22).
3. Position the unit to allow a clear view through the gap between the cradle and the rim of the metallic
WDS housing (FIG. 23). This view allows you to orient the alignment between the tip of the
screwdriver and the screw holding the support cradle to its associated movement mechanism.
FIG. 21 Faceplate removal from MVP-WDS
Faceplate
Faceplate securing latches
As you are removing the faceplate, you will have to press down on the Security Latch
to allow a complete removal of the faceplate.
FIG. 22 Removing the MVP Support Cradle securing screws
MVP Support Cradle
Securing screws (2)