SecurityMan Air-AlArm1 - User manual - Manual (Page 23)

20
Problems Possible Cause solutions
The alarm host sounded off immediately
after connecting the power
The telephone incoming line has not
been connected, poor connection or
short circuit. Double check, test and secure the incoming telephone line
or use a standard phone to test the line to ensure working
status.
The alarm host cannot record or partially
records
The record switch is not turned on. The
Record buttons not pressed down and
held while attempting to record, or not
held down all the way.
Slide the record switch to the “ON” position; Securely
press and hold down the RECORD button during recording.
Speak up close to the rear speaker of the host.
Repeatedly receiving the alarm telephone
No one picked up the alarm calls or
failure to press the * star button to end/
drop the call.
After answering the alarm phone calls and hearing the
recorded message: please advanced to page 5 (telephone
Alarm) of this user’s manual as a reference to try to resolve
this problem, or simply press the * star button to end the
call.
The alarm host does not sound the
alarm after the detector triggered the
alarm in armed mode.
1. The wireless devices may not have
synchronized with the alarm host.
2. The dwell time for Entry Delay or Exit
Delay has not been reached.
1. In “Home” mode, make sure the sensor or wireless devices
triggering is not in the 2nd Defense Line. Simply cancel the
wireless devices and add them in again to synchronize with
the host.
2. Ensure the sensor detectors are not active within the
system setup Entry Delay Time or Exit Delay Time, default
delay time is 40 seconds
The PIR motion sensor does not work
Weak battery power, not switched on,
or the PIR motion detector is in the
power-down mode
Open the sensor shell to install the battery and slide the
power switch to “On”. Power down mode may be in affect:
“5S”: detect once every 5 seconds “5MIN”: detect once every
5 minutes, please refers to the user’s manual for PIR setup.
Common Problems and solutions