SecurityMan Air-AlArm1 - User manual - Manual (Page 9)

6
operation
to record a voice message greeting: Slide the switch on the left side of the alarm host to the RECORD ON position, press and hold the microphone
button, speak close (6”) into the rear speaker of the host, and then release the microphone button when finished with your voice message greeting.
Voice message greetings can be anywhere between 0~9 seconds long.
to Playback the recorded voice message greeting: Slide the switch on the left side of the alarm host to DC ON, press and hold the playback button
to playback the recorded voice message greeting. An alarm sound message is pre-recorded by default.
“one-key” Arm:
by remote controller: Press the AWAY (All Alarm) or the HOME (Part Alarm) button on the remote control to arm and the alarm host will beep once to
confirm the operation is successful. See Wireless Remote Controller on page 8 for more detail.
by Keyboard on alarm host: Press (All Alarm) or (Part Alarm) button, the alarm host will beep once to confirm the operation is successful.
“one-key” Disarm:
by remote controller: Press the DISARM button on the remote control to disarm the alarm and the alarm host will beep twice to confirm the operation is
successful.
Disarm by keyboard on alarm host: _esC/Disarm + Programming Password + eNt__ Press the ESC/Disarm button follow by the programming
password and then ENT to disable alarm siren using the alarm host. The host will beep twice to confirm the operation is successful.
emergency/Panic Distress:
by remote controller: Press the EMERGENCY
button on the remote control at times of emergency to immediately activate the sound siren on the
alarm host and wireless sirens.
by Keyboard on alarm host: Press the EMERGENCY
button on the alarm host at times of emergency to immediately activate the siren sound on the
alarm host and wireless sirens.
telephone alarm: After receiving the phone call from the alarm host, the recorded voice message will repeatedly play for 22 seconds. Before the 22
seconds are over, one of the following actions must be taken:
A) Press the number “8” on the phone pad to extend the time intervals for an additional 20 seconds to enter the listening state. In the listening state
the built-in microphone on the alarm host will be active to pick up any sound that takes place near by the alarm host.
b) Press the pound “#” button to replay the recorded voice message.