SecurityMan Air-AlArm1 - User manual - Manual (Page 7)

4
Programming the Alarm Host (sm-8088e)
_function_:_operation__Operation Explanation
Notes:
1. The alarm host will automatically exit from the programming status if inactive for 20 seconds.
2. Programming is effective after _SET+Password+ENT_, use ESC button to go to previous step.
3. The alarm host will beep in series to indicate the operation is successful and beep once to indicate operation failure.
_:_set + Password + eNt__ This command applies throughout whenever programming the alarm host, before attempting to change other programming
features, such as Delay Time to Arm, Delay Time to Alarm, Emergency Alarm Voice, Adding and Cancelling wireless devices, etc . For example; to change
Delay Time to Arm below from the default 40 seconds to 1 minute, press_SET + 888 + ENT_ follow by _15 + ENT_. The programming default password is
888 (3 digits long), and 15 is the
programming code for 1 minute.
_input Alarm telephone Number_ : _XX + eNt + telephone Number + eNt__ XX indicate telephone group number which can be of personal numbers
or management center. See group details below:
01: Group 1 (personal telephone number)
02: Group 2 (personal telephone number)
03: Group 3 (personal telephone number)
04: Group 4 (personal telephone number)
05: Group 5 (personal telephone number)
06: Group 6 (reserved for CID Protocol number for management center, not for personal numbers, requires monthly fees)
To delete or reset the telephone enlisted number press, “SET+password+ENT+XX+ENT+ENT (XX is the group number, ie. 01, 02, etc.)
_Delay time to Arm_: _XX + eNt__ Setup a dwell time in which the alarm will become activated or armed. Enter 10 for XX to setup Delay Time to Arm for
40 seconds, enter 15 to setup Delay Time to Arm for 1 minute and press the ENT button to confirm. The default setting is 10 or 40 seconds alarm dwell time.
If armed, any wireless triggers within the dewll time of 40 seconds or 1 minute, the Alarm Host will beep twice.
_Delay time to Alarm_: _XX + eNt__ Setup a dwell time in which the alarm will sound or trigger. Enter 20 for XX to setup immediate alarm sound trigger-
ing, enter 21 to setup a 15 seconds Delay Time to Alarm. The default setting for Delay Time to Alarm is 20.
_emergency Alarm sound_: _XX + eNt__Enter 30 for XX to disable Emergency Alarm Sound, enter 31 to setup audible alarm sound, the default is 31.
During the Emergency Alarm Sound is disabled or set to 30; the alarm host will operate normal, and will continue to dial the enlisted phone numbers in
case of emergency.