SecurityMan Air-AlArm1 - User manual - Manual (Page 8)

5
_Alarm sound for 1st and 2nd defense line_: _XX + eNt__ Enter 40 for XX to disable alarm sound for 1st & 2nd defense line, enter 41 to enable Audible
alarm, the default is 41. When the Alarm Sound is disabled or set to 40; the alarm host will operate normal and will continues to dial the enlisted phone
numbers upon alarm trigger.
_telephone Disconnection Alarm_: _XX + eNt__ Enter 60 for XX to disable Telephone Disconnect Alarm, enter 61 to enable Telephone Disconnect Alarm,
the default is 61. Telephone Disconnection Alarm is line of integrity alarm. That chirps every 5 seconds when the telephone line is not connected to the TEL
IN port of the alarm host panel. To disable the chirping when the telephone is not plugged in to the host; press, “SET+password+ENT+60+ENT.
_to upload arm/disarm to management center_: _XX + eNt__Enter 50 to disabled upload, enter 51 to enable upload to management center, the default
setting is 50 or disable. Leave this disable if management center is not in service.
_User Code_: _80 + eNt + XXXX + eNt__ Enter a number between 0000~9999 for XXXX to setup user code for management center. The default is set as
random; apply to management center use only.
to setup User Code (for Ademco management Center):
_set + 999 + eNt + press“ ”button + eNt + enter programming code + eNt + 3 digits user’s code + eNt + re-enter user’s code + eNt__ press
“SET” and programming will appear, enter “999” press “ENT” and then press“ ”page up/down to choose “revise user’s code” and press “ENT”, enter
programming code, press “ENT” enter 6 digits user’s code, and press “ENT”, reenter user’s code, and press “ENT“.
Note: user’s code cannot be same as programming password 999 and programming code! Press ESC to exit from programming when finished.
How to change the programming password
_set + 999 + eNt + three Digit New Programming Password + eNt + three Digit New Programming Password + eNt__ Press SET button, the
programming LED light will come on, enter “999”, press ENT, then input a new three-digit programming password, press ENT, re-input the new three-digit
programming password, and then press ENT to complete the programming password change. Notice the programming LED light will disappear after the
final ENT is pressed.