SecurityMan LCDDVR4 - Manual (Page 39)

33
Sensitivity is use to adjust the sensitivity level of video motion detection (built-in
software driven) on the DVR system. The sensitivity value level can be set to
1, 2, 3, 4, and OFF (system default). The most motion sensitivity level is 1; the
higher the number, the less sensitive the video motion detection which requires
more movements in the image to trigger motion sensor. In the default OFF
position mean the Motion detection will not be detecting any motion and turn off
Press Menu/ESC or right click mouse anytime to exit out of Motion Detection
setup menu and back to Alarm setup menu.
Select Motion Area from the Motion Detection setup menu to access the
motion area setup window. Motion Area is use to mask the range of motion
detection area within the camera image. The range of motion detection block
area is limited to one block of any size, multiple motion detection block areas is
not permitted by the system.
To select or highlight motion area of detection using the front panel or RC
(remote control); move the cursor to a desire point in the image, press the
Select/Enter button once, next use the CH2↓/(DOWN) and then CH4→ button
on the front panel or RC to highlight the area of detection (blue film highlight
color), press the Select/Enter button again to confirm the selection and to
release the cursor from the highlighted block area. Press Menu/ESC button at
anytime to exit from Motion Area setup window.
To select or highlight motion detection area using mouse control; click-hold
down the left mouse click at a desire location in the camera image and then
drag the mouse cursor in a down-right directional movement to mask the area
of detection (blue film highlight color). Use right mouse click anywhere in the
Motion Area window to confirm the masking area and exit out from Motion Area.
IMPORTANT NOTE: To start Motion Record; Motion Schedule (page 28),
Sensitivity level and Motion Area must be setup as instructed above.
During Motion Area masking, the CH1↑/(UP) and CH3← button and an
upward/leftward mouse directional movement cannot be use to mask
the motion detection area.