Alamo SR14 - Manual (Page 138)

MAINTENANCE
MAINTENANCE
SR20M/SR14M 11/01 Maintenance Section 5-8
© 2004 Alamo Group Inc.
Figure 19) Slide the shield tube assembly over the shaft, so that the bearing hles in the shield
align with the shield bearing groove on the yoke.
Figure 20) Install two shield bearings per half shaft by pushing one bearing in each bearing
hole. The shield bearings should be installed in the direction of the shaft rotation relative to the
shields
Figure 21) Attach safety decal as needed.
Figure 21
Figure 20
Figure 19