Alamo SR14 - Manual (Page 147)

MAINTENANCE
MAINTENANCE
SR20M/SR14M 06/98 Maintenance Section 5-17
© 2004 Alamo Group Inc.
STEP 5
Remove all eight Bolts from Input Cap using a 14mm Socket. Then using a Hammer, tap the Output end of the
Input Shaft. This will loosen the input Cap and allow the removal of the complete Input Shaft Assembly. FIGURE 30.
STEP 6
The Input Gear and Bearing can be removed from the Input Shaft by tapping the end of the Input Shaft on a solid
surface. FIGURE 31.
The unit is now completely disassembled with exception of Oil Seals and Bearing Races that can be removed by
conventional means. FIGURE 32.
Inspect and replace all worn or defective parts.
FIGURE 30
FIGURE 31
FIGURE 32