Alamo SR14 - Manual (Page 146)

MAINTENANCE
MAINTENANCE
SR20M/SR14M 04/94 Maintenance Section 5-16
© 2004 Alamo Group Inc.
STEP 3
Remove the Hub Assembly from the vise and place it on a solid surface with the Gear in an upright position. Using
a Hammer, tap this Gear downward until the Adjusting Nuts fully exposed. Remove the Cotter Pin. Remove the
Adjusting Nut. FIGURE 28.
STEP 4
Laying the Hub Assembly on its side, tap the Gear end of the Output Shaft into the Gear and Bearing. Once the
Shaft has cleared the Bearing, it can be fully removed from the Hub Assembly. The remaining Bearings and
Bearing Cups can be removed by conventional means. FIGURE 29.
FIGURE 28
FIGURE 29