Alamo SR14 - Manual (Page 149)

MAINTENANCE
MAINTENANCE
SR20M/SR14M 06/98 Maintenance Section 5-19
© 2004 Alamo Group Inc.
FIGURE 40 FIGURE 41
STEP 3
Apply some Locktite on the Adjusting Nut FIGURE 38. Install the Adjusting Nut onto the Shaft FIGURE 39. Tighten
the Nut until it is difficult to turn the Shaft FIGURE 40. While holding Hub, tap each end of the Shaft and check to
see if it has loosened. Repeat this process until the Shaft no longer becomes loose in the assembly. Unscrew the
Nut a small amount and again tap each end of Shaft while holding the Hub. Repeat this process until a rolling
torque of 10 to 12 inch pounds is reached on the Shaft. Install Cotter Pin FIGURE 41making sure it does no Bend
over the end of the shaft.
FIGURE 39 FIGURE 38