IAI America PCON-CFA - Manual (Page 268)

6. Appendix
262
[4] A list of slaves will be displayed in which five items, RC-ECT-FMOD [0 ~ 4], are registered to
Controller under IAI. The ending number represents the Field Bus Operation mode setting (Note 1) .
Select the item ending with the same number as the current setting.
Set the node address (Note 2).
Set the slave name (any) and select OK.
(Note 1) Parameter No.84 setting [Refer to 2.5.1, 3.5.1 or 4.5.1 Operating Mode Selecting.]
(Note 2) Set this to the same value as parameter No. 85 of ACON, PCON or SCON-CA.
[Refer to 2.5.2, 3.5.2 or 4.5.2 Station No. Setting.]
[5] Repeat step [4] to set all slaves.
From the menu of the NCF tool, select NC unit and then Transfer [PC o NC].