LiftMaster SL575 Heavy-Duty Commercial Slide Gate Operator - Manual (Page 24)

24
NOTES
1. Severe or high cycle usage will require more frequent
maintenance checks.
2. Inspection and service should always be performed anytime a
malfunction is observed or suspected.
3. Limit switches may have to be reset after any major drive chain
adjustments.
4. If lubricating chain, use only a proper chain lube spray or a
lightweight motor oil. Never use grease or silicone spray.
5. When servicing, please do some “house cleaning” of the
operator and the area around the operator. Pick up any debris
in the area. Clean the operator as needed.
6. It is suggested that while at the site voltage readings be taken
at the operator. Using a Digital Voltmeter, verify that the
incoming voltage to the operator is within ten percent
(+ or -) of the operators rating.
To reduce the risk of SEVERE INJURY or DEATH:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. NEVER let children operate or play with gate controls.
Keep the remote control away from children.
3. ALWAYS keep people and objects away from the gate.
NO ONE SHOULD CROSS THE PATH OF THE MOVING
GATE.
4. Test the gate operator monthly. The gate MUST reverse
on contact with a rigid object or stop when an object
activates the non-contact sensors. After adjusting the
force or the limit of travel, retest the gate operator.
Failure to adjust and retest the gate operator properly
can increase the risk of INJURY or DEATH.
5. Use the emergency release ONLY when the gate is not
moving.
6. KEEP GATES PROPERLY MAINTAINED. Read the
owner’s manual. Have a qualified service person make
repairs to gate hardware.
7. The entrance is for vehicles ONLY. Pedestrians MUST
use separate entrance.
8. Disconnect ALL power BEFORE performing ANY
maintenance.
9. ALL maintenance MUST be performed by a LiftMaster
professional.
10.
SAVE THESE INSTRUCTIONS.
WARNING
WARNING
WARNING WARNING
RPM Sensor (Hall Effect) Check for proper adjustment X X X
Entrapment Check for proper operation X X X
Protection Systems
Warning Signs Make sure they are present X X X
Clutch System Check and adjust if required X X X
Belt Check for excessive slack or wear X X X
Brake System Check and adjust if required X
Manual Disconnect Check and operate X X
Drive Chain Check for excessive slack and lubricate X X
Sprockets and Pulleys Check for excessive slack and lubricate X X
Gate Inspect for wear or damage X X
Accessories Check all for proper operation X X
Electrical Inspect all wire connections X X
Frame Bolts Check for tightness X X
Total Unit Inspect for wear or damage X X
DESCRIPTION TASK 3 MONTHS 6 MONTHS 12 MONTHS
CHECK AT LEAST ONCE EVERY
IMPORTANT SAFETY INSTRUCTIONS
O P E R A T I O N A N D M A I N T E N A N C E