Teka GKST 95 N i4 Select - Manual (Page 23)

Operation GB
23
Operating the buttons
The controls described here expect the pressing of a (selection) button to be
followed by the pressing of a subsequent button.
The pressing of a subsequent button must always commence within
10 seconds, otherwise the selection will be deleted.
The plus and minus buttons can be touched individually or be permanently
pressed.
Switching on the hob and cooking zones
1. Press the on/off button until the power setting displays indicate 0.
The stand-by dots will blink. The controls are ready for operation.
2. Then press a cooking zone selection button (e.g. for front left). The
stand-by dot of the cooking zone selected will light up.
3. Use the plus button or minus button to select a cooking level.
The plus button will activate power setting 1 and the minus button power
setting 9.
4. Put a metal cooking pot onto the cooking zone. The pan recognition
device will activate the induction coil.
As long as no metal cooking pot is placed onto the cooking zone, the dis-
play will alternate between the power level set and the symbol . If no
pot is placed on the cooking zone it will switch off after 10 minutes for rea-
sons of safety. Please refer to the section on “Pan recognition” .
Repeat items 2 to 4 in order to cook on other cooking zones at the same time.
Switching off a cooking zone
5. The stand-by dot of the cooking zone selected must light up. It may be
necessary to press the cooking zone selection button.
6. a) Press the minus button several times until the power setting
display shows 0, or
b) press the minus button and the plus button once at the same
time. The cooking zone is switched off direct irrespective of the power
setting or
c) press the on/off button . The entire hob will be switched off (all of
the cooking zones are switched off).
Switching off the hob
7. Press the on/off button . The hob will be completely switched off,
irrespective of any settings.
Suitable for induction cooking
Cooking zone selection buttons Stand-by dot