Teka GKST 95 N i4 Select - Manual (Page 27)

Operation GB
27
Power boost setting
(cooking zones marked with a P)
The power boost setting makes additional power available for induction
cooking zones. A large quantity of water can be brought to the boil very
quickly.
The power boost setting operates for 10 minutes, after which the power level
is automatically reduced to cooking level 9.
1. A cooking zone must be switched on. The stand-by dot of the cooking
zone must light up. It may be necessary to press the cooking zone
selection button.
2. Press the power button once in order to activate the power boost set-
ting. The power display will show a P.
3. After 10 minutes the power boost setting will switch off automatically. The
P will go off and the power level will switch down to 9.
Note!
In order to terminate the power boost setting press the minus button
or
the power button .
Power management
For technical reasons two cooking zones always comprise a module and
have a maximum power level.
If this power range is exceeded when a higher power setting level or the
power boost function is switched on the power management system will
reduce the power setting of the corresponding cooking zone of the module.
The display of this cooking zone will initially blink; the maximum possible
power setting will subsequently be shown constantly.
Modules (power management)