Teledyne LeCroy WaveAce - Manual (Page 10)

Getting Started Manual
WA-GSM-E RevB 10
On (Supply). This is the AC mains connect/disconnect switch at the back of
the instrument.
Off (Supply). This is the AC mains connect/disconnect switch at the back of
the instrument.
This symbol shows that the switch is a Standby (power) switch located on
the front of the oscilloscope. Pressing this button toggles the oscilloscope’s
state between operating and Standby mode. This switch is not a
disconnect device. The instrument can only be placed in a complete Power
Off state by flipping the main power switch to the off (Zero) position or by
removing the power cord.
This symbol is used to denote Alternating Current.
CAUTION
The CAUTION sign indicates a potential hazard. It calls attention to a
procedure, practice or condition which, if not followed, could possibly
cause damage to equipment. If a CAUTION is indicated, do not proceed
until its conditions are fully understood and met.
WARNING
The WARNING sign indicates a potential hazard. It calls attention to a
procedure, practice or condition which, if not followed, could possibly
cause bodily injury or death. If a WARNING is indicated, do not proceed
until its conditions are fully understood and met.