Teledyne LeCroy WaveAce - Manual (Page 31)

WaveAce Series
31 WA-GSM-E RevB

Armed - The oscilloscope is acquiring pre-trigger data. All
triggers are ignored in this state.

Ready - The oscilloscope is ready to trigger.

Trig'd - The oscilloscope has found a trigger and is acquiring
the post-trigger data.

Stop - The oscilloscope has stopped acquiring waveform data.
Shown in red highlight.

Acq. Complete - The oscilloscope has completed a Single
Sequence acquisition.

Auto - The oscilloscope is in Auto Mode and is acquiring
waveforms in the absence of triggers.

Scan - The oscilloscope is acquiring and displaying waveform
data continuously in Scan Mode.
2. USB Memory Device - Indicates whether the USB Memory Device is
inserted in the USB Port.

When a USB Memory Device is not inserted in the USB Port
the area is blank.

USB Memory Device is inserted in the USB Port (as shown
previous).

When plugging in or removing a USB Memory Device, a
message is briefly shown on the grid display as USB Flash
Drive Plug In! and USB Flash Drive Pull Out!, respectively.
3. Waveform Preview Display - This small portion at the top of the
screen shows how much of the captured waveform is currently
appearing on the display.
Note: Show the full waveform by stopping the trigger and turning
the Time/Div button to the left (increasing the amount of time
shown on the display).
4. Print Key - Indicates whether the Print Key option is set to Print
Picture or Save Picture.

Print Key option set to Save Picture (as shown previous).

Print Key option set to Print Picture