Teledyne LeCroy ZS2500 - Manual (Page 8)

ZS Series High-Impedance, Active Probes
Operating Environment
The accessory is intended for indoor use and should be operated in a clean, dry
environment. Before using this product, ensure that its operating environment is
maintained within these parameters:
Temperature: 5 to 40° C.
Humidity: Maximum relative humidity 80 % for temperatures up to 31 °C
decreasing linearly to 50 % relative humidity at 40° C.
Altitude: Up to 10,000 ft (3,048 m).
Introduction
The ZS1000, ZS1500, and ZS2500 are small, high impedance active probe
designed to meet today’s increasing demand for measurements on a variety of
test points. With low input capacitance and high input resistance, circuit loading
is minimized.
The ZS2500 can be used with Teledyne LeCroy’s WaveSurfer, WaveRunner,
WavePro and WaveMaster series platforms with firmware version 6.5.0.5 or
later.
With the ProBus interface, the ZS1000, ZS1500, and ZS2500 become an integral
part of the oscilloscope. The probe can be controlled from the oscilloscope’s
front panel. The oscilloscope provides power to the probe, so there is no need
for a separate power supply or batteries.
Key Benefits
• High frequency performance
• Low input capacitance
• Wide dynamic range
• ProBus interface
2 924282-00 Rev A