Teledyne LeCroy SierraNet M168 User Manual Ver.1.40 - Manual (Page 132)

Teledyne LeCroy Trigger and Filter Settings in Easy Mode
130 SierraNet M168 User Manual
FCAV Patterns
 FCAV(Simple)
 FCAV(Extended)
2.6.21 Protocol Errors
Double‐click Protocol Errors to open the dialog.
Figure 2.82: Protocol Errors Dialog
Select the desired protocol errors or click on the Check All box to select all the errors.
Enter the count of the expected number of occurrences. Check the Check All box to
select ports P1 through P4 or individually select ports.
2.6.22 Trigger Setup
The Trigger tab in the analysis project dialog allows you to specify when the analyzer
completes a data capture. Two trigger modes are available: The default mode is Snapshot
or you can select Pattern/Event Trigger.
When data capture starts with Don’t care (Snapshot) selected, the analyzer triggers on
the first data pattern on the bus.