Add state – Teledyne LeCroy SierraNet M168 User Manual Ver.1.40 User Manual
Page 136
Advertising
Teledyne LeCroy
Advanced Mode (User‐Defined)
134
SierraNet M168 User Manual
You can:
Display the state definition
Set Output Trigger level
Select up to three timers
Define the If condition and up to three Else If conditions
Set number of occurrences before trigger
Set captured data
Set excluded data
Go to next state
Add state
Choose link for Sequencer setup
Figure 2.86: State Programming Dialog
Add State
Click on the Add State
button to add a State to the Sequencer. A State will be
added below the last State.
Advertising