Teledyne LeCroy SierraNet M168 User Manual Ver.1.40 - Manual (Page 217)

SierraNet M168 Protocol Analyzer User Manual 215
Scenario Example LeCroy Corporation
Figure 4.18: Adding Action Monitor/Count for Sequence 1
4. Click the OK button to close the Monitor/Count dialog box.
5. Repeat step 4 to add another Action (if desired).
The completed Scenario is shown in Figure 4.19 on page 215 .
Figure 4.19: Complete Scenario of Insert DWORD Matcher
4.6.2 Sequence Creation
A sequence can have multiple states, but only one state is active at any time. In other
words, at any point in time, a sequence “waits” for one Event (or Combined Event) and
responds with the corresponding Action or set of Actions when the Event occurs.
A sequence is more powerful than Global Rules, because you can create branching or
looping test logic with a sequence.You can include up to two sequences in a Scenario, but
each is completely independent of the other. There is no branching or other interaction
between the two, except through the Restart All Sequences Action.