Tracer TP-1130 M-L A03125-2 - Manual (Page 18)

PROBLEM SOLVING:
No fluorescence in the water flow.
• Make sure the dye valve is in the ON position.
• Increase the water flow to increase the dye flow.
• To clean a clog from the small end of the gun, run hot water over it or probe the clog with
a fine wire.
• Add 0.25 ounce (7.4 ml) dye at a time to the bottle.
ADDITIONAL USES FOR THE TracerJet™ SPRAY GUN
FLUSH THE COOLING SYSTEM (See Figure 2)—
CAUTION
Extreme care should be taken when flushing
cooling systems in poor condition
• Loosen the retaining collar and twist off the bottle assembly.
• Twist the stepped nozzle into place.
• Remove the thermostat from the system and turn the heater to the ON position.
• Disconnect the lower cooling hose from the engine block.
• Insert the stepped nozzle into the lower hose and secure with a clamp.
• Turn on the water supply.
• With water running, give short, intermittent blasts of air until water runs out clear.
• Reassemble the system and refill with recommended coolant and pressure test for leaks.
AIR BLOW FUNCTION (See Figure 3)—
• Remove the bottle assembly from the gun.
• Unscrew the tap fitting from the rear of the gun.
• Install the accessory tail fitting.
• Attach to the air compressor.
PRESSURE WASHER—
• Fill the bottle with detergent or degreaser fluids.
• Rinse the bottle well between uses.
Tracerline ® TP-1100H UV/Blue™
12-Volt, 50-Watt Leak Detection Lamp
OPERATION (See Figure 4)—
• Connect the TP-1100H lamp to the cigarette lighter in the vehicle, or use the supplied
12V TP-1517 adapter cord to attach to the vehicle’s battery. (The TP-1509 12V-battery
pack—available as an accessory—includes a 120-volt charger and nylon carrying case.
The TP-1509/F battery pack includes a 230-volt charger.)
• Scan the interior of the vehicle. You must wear the TP-9940 glasses supplied. They
eliminate reflected UV/blue light from the lamp, which could mask the fluorescent glow
from leaks. The glow will show best under low light conditions.
TO REPLACE THE BULB
Use only the 50-watt TP-1110 bulb. Using any other bulb may damage the lamp and
will void the warranty.
• Disconnect the lamp from the power source.
• Twist off the bulb guard and gently pull the old bulb straight out from the socket.
• Holding the new bulb by the edge of the reflector, press it into the two-pin socket firmly
but gently.
• Reattach the bulb guard.
18 3
1
2
Figure 3
English
1. Remove bottle assembly or
stepped fitting
2. Remove tap fitting
3. Install tail fitting
4. Attach to the air compressor
3
4
French
1. Dépose de la bouteille ou de
la buse
2. Dépose du raccord pour
robinet
3. Installation du raccord arrière
4. Fixation au compresseur d'air
Spanish
1. Remueva el conjunto de la botella
o la boquilla escalonada
2. Remueva el tapón macho de rosca
3. Instale el accesorio de cola
4. Conecte al compresor de aire
German
1. Flaschenteile oder gestuftes
Anschlussstück abnehmen
2. Hahnanschlussstück
abschrauben
3. Endanschlussstück
anbringen
4. Mit Luftkompressor verbinden