Warner Electric ZRC Clutch_ARC Top Load - Manual (Page 11)

Warner Electric • 800-825-9050 P-2018 • ZRC/ARC 11
ARC Top Load Rebuild Procedure
Using a small standard screwdriver remove snap
ring. See Figure 52.
Figure 47
Remove spring plate, upper spring cover(if
applicable), spring, and lower spring cover (if
applicable) from top-load assembly. See Figure
53.
Figure 48
Remove internal shaft and inspect for wear,
replace as necessary. Clean all parts. See Figure
54.
Figure 49
Install new pins, apply a thin layer of grease to
internal shaft and pins. See Figure 55.
Figure 50
Remove seal and replace. See Figure 56.
Figure 51
Apply a thin layer of grease the seal and bore. See
Figure 57.
Figure 52