Warner Electric ZRC Clutch_ARC Top Load - Manual (Page 7)

Warner Electric • 800-825-9050 P-2018 • ZRC/ARC 7
With a 1/8” 3mm hex wrench, loosen the set
screw that holds the top load assembly and clutch
together. See Figure 22.
Figure 22
Using Spanner wrenches (YTL3-0009 & YTL3-0008)
and soft hammer, separate the clutch from the top
load assembly. See Figure 23.
Figure 23
Remove two set screw with a 3/32” 3mm hex
wrench. See Figure 24.
Figure 24
ZRC
Clutch Rebuild Procedure
Remove the three torx screws using a T-15 security
torx bit. See FIgure 25.
Figure 25
Place chuck output shaft in vice, clamping on flats.
Using a socket, FIX-0004, and a breaker bar, remove
ring nut on top of clutch. See Figure 26.
Figure 26
Remove housing from clutch. See Figure 27.
Figure 27
FIX-0004